This listing is for a pack of 10
Ideal for welding patch repairs in floors, wings, door skins etc.
Ideal for when assembling fabricated panels on reskinning projects
The Intergrips will clamp either flat, curved or even pressed ribbed panels.
These will hold any shape panel in place anywhere, either edge to edge and perfectly prior to butt welding
Small gap (0.4mm) allows full penetration of the weld.
Simple and easy to use once the two sections are tack welded together, slacken the wing nut, remove the toggle bar and remove the clamp from the job and then finally weld the metal together.
End outcome is a welded butt joint with very little dressing being necessary.
A very useful kit of temporary fasteners. Simply drill a hole in two panels and insert a pin using the pliers to provide a temporary fixing between the panels.
This fastener can be removed and replaced as many times as necessary until the panel is finished. Then you can either put in a permanent fastener such as a pop rivet or bolt, or the panel can be welded and the hole filled.
Originally used in the aviation industry these pins have become very popular for all kinds of sheet metal work, from temporarily assembling ducting to securing body panels.
Also included in the kit is a pair of edge clamps, used at the end of a joint or for other clamping requirements on the edge of a panel.
These clamps are much smaller and easier to work around than traditional welding clamps or G clamps and also provide a more accurate alignment as they are located in holes.
10 x 1/8" (3mm) Cleco Pins
2 x Edge Clamp
1 x Plier Insertion Tool (Supplied with either blue or black handles)
10 x Intergrips